The Ccon102 controller is like a mobile U disk. First, connect it to a computer. Next, open the “my computer”folder on the computer desktop. Finally, open the “removable disks” folder, and you will find the programs you want to delete. Delete the programs.
First, remove the batteries from the controller. Next, connect the configurator and the batteries to charge the batteries separately.
There is an indicator on the charger. When the indicator shows red light, it indicates that charging is ongoing; whereas a green indicator indicates that the battery is fully charged. To ensure safe use, please do not exceed 12 hours for a single charge.
The memory size of the controller is 3.96 MB. The size of a program is usually 150 kb – 500 kb. Therefore, a controller can store up to about 27 programs.
The program the user writes with the C language cannot be converted into a flow diagram. However, a flow diagram can be completely converted into a corresponding program written with the C language.
It should be connected to the Motor port.
The battery used in the set is a lithium battery. It is recommended that the battery be charged once a month if it is not used for a long time.
Yes. You may use the “start motor” modulein the program. In this case, the car is navigated according to time rather than the navigation line.
The initial setup of the program is “collect from the environment”.
There is some impact but the normal navigation line is not affected because the luminosity of the gray sensor under the car is strong enough and navigation is primarily affected by the gray sensor.
Both are game sets officially designated by the WER.